A c c u e i l

Steca Xtender XTH

3000-12, 5000-24, 6000-48, 8000-48

The inverter, battery charger, the switching function and the support of external sources of AC are the basic functions of the combined inverter of the Steca Xtender series. These functions can be combined and controlled fully automatically, providing an outstanding user comfort and a very good use of the available energy.

It is possible to make all the settings of the Steca Xtender XTH with the remote. If the software is available with new features, it can be integrated into the system so the Steca Xtender XTH always at the forefront of technology. Several Steca Xtender XTH can be connected in parallel and in phase. This allows for up to nine Steca Xtender together.

Multifunction Contacts

These potential-free contacts can be programmed for many different applications. They can react to any external or internal event to the inverter (Network availability, Battery voltage, error message …). It is also possible to program a timer or turn them over a defined period (la nuit, le week-end…). They can therefore be used as device start generator, to disconnect consumers smaller, a fault, to charge the battery according to the situation, etc..

 [spoiler title=”Documentation PDF” open=”false” closebtn=”Close”]

Steca Xtender XTH

Manual Additional manual Datasheet Product catalog in isolated

Download (PDF, 2.7MB)

Download (PDF, 2.6MB)

Download (PDF, 665KB)

Download (PDF, 9.72MB)

[/spoiler]49

Fonction Smart-Boost

Smart-Boost function to increase the power of another AC source, such as a power generator or a connection to earth, even if it is of special consumer (Inductive, asymmetric, with high switch current). The Steca Xtender XTH can be combined with almost all inverters already in place to increase the power available.

 
Product Features
  • Tension pure sinusoidal
  • Excellent overload capacity
  • Optimal battery protection
  • Adjustable integrated battery charger
  • Programmable battery charger at plural positions with power factor correction (CFP)
  • Automatic load detection
  • Possibility to adjust the load detection in standby mode from a low value in a wide range
  • Possibility of parallel connection
  • High reliability
  • Can be used as a backup system or uninterruptible power supply (ASI)
  • Multifunction contact
  • Distribution of the adjustable power (Power Sharing)
  • Reliability and discretion for all types of consumers
  • Extra sources of alternating current (Smart Boost)
  • Automatic support for peak power (Power Shaving)
  • Fast switching relay
  • High level of energy efficiency
  • Control by a digital signal processor (DSP)
Electronic protection functions
  • Protection against deep discharge
  • Disconnection when the battery voltage
  • Protection against overtemperature and overload
  • Protection against short-circuit
  • Protection against reverse polarity by internal fuse (Autre that Xtend XTH Steca 3000)
  • Audible alarm at deep discharge or overheating
Views
  • 5 LEDs indicate operating states
    – for service and fault messages
Control
  • Main switch
  • Adjustable load detection
Options
  • Model 115 In / 60 Hz (Autre that Xtend XTH Steca 8000-48)
  • Model with protective lacquered mainboard
  • Temperature sensor BTS-01 to adapt the threshold voltage at the temperature of the battery
Certificates
  • Compliant with European Standards (EC)
  • RoHS Directive

Solar inverters